Toshiba Qosmio E10 - Manual (Page 164)

User’s Manual 9-15
Troubleshooting
Modem
Display error occurs Check that the cable connecting the external
monitor to the computer is attached firmly.
If problems persist, contact your dealer.
Problem Procedure
Problem Procedure
Communication
software can’t initialize
modem Make sure the computer’s internal modem
settings are correct. Refer to Phone and Modem
Properties in the Control Panel.
You can hear a dial
tone but can’t make a
call If the call is going through a PBX machine, make
sure the communication application’s tone dial
detection feature is disabled.
You place a call, but a
connection can’t be
made Make sure the settings are correct in your
communications application.
After making a call you
can’t hear a ring Make sure the tone or pulse selection in your
communications application is set correctly.
Communication is cut
off unexpectedly The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.
A CONNECT display is
quickly replaced by NO
CARRIER Check the error control setting in your
communications application.
Character display
becomes garbled
during a
communication In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
You cannot receive an
incoming call Check the rings before auto answer setting in
your communications application.
If problems persist, contact your dealer.