Toshiba Qosmio E10 - Manual (Page 105)

User’s Manual 5-5
The Keyboard
Hibernation Mode: When you press Fn + F4, the computer enters
Hibernation Mode. To avoid entering Hibernation Mode unexpectedly, a
dialog box appears for verification. However, if you select the check box, it
will not appear in the future.
Display selection: Press Fn + F5 to change the active display device.
When you press these hot keys, a dialog box appears. Only selectable
devices will be displayed. Hold down Fn and press F5 again to change the
device. When you release Fn and F5, the selected device will change. If
you hold down these hot keys for five seconds the selection will return to
LCD.
LCD Display Brightness: Pressing Fn + F6 decreases the display
brightness in decrements. When you press these hot keys, the current
setting will be displayed for two seconds by an icon. You can also change
this setting through the Screen brightness item of the Basic Setup tab in
TOSHIBA Power Saver.
LCD Display Brightness: Pressing Fn + F7 increases the display
brightness in increments. When you press these hot keys, the current
setting will be displayed for two seconds by a pop-up icon. You can also
change this setting through the Screen brightness item of the Basic Setup
tab in TOSHIBA Power Saver.
During the Monitor-in mode, Fn + F5 is not available.
■
The brightness level is always set at the maximum value for about 18
seconds, when the LCD turns on. After 18 seconds, the brightness
level will appear at the Power Save Mode setting or you can change it
manually.
■ Display clarity increases with the brightness level.