Toshiba Magnia 3310 - Manual (Page 13)

4
Fault report function
If a fault occurs in the Agent machine, fault information can be reported to the
Management Console. There are two ways to send a report to the Management
Console:
1. Displaying an Alert Message on the Management Console
2. Sending e-mail to a designated component (Management Console or other)
Five fault levels are specified: Information, Warning, Error, Success Audit, and Failure
Audit.
Events written to the event log on the Agent machine are reported to the Management
Proxy. These events reported by the Agent function can be filtered.
(3.3.10 Configure Alerts screen)
Information on faults at the Agent machine that were reported to the Management Proxy
can be filtered and forwarded to the Management Console or to an e-mail destination.
(3.4.4 Alert Message Location screen)
(3.4.6 Email Address screen)
Front panel indicator function
It enables the user to type a specified character string via the Management Console to
change the information displayed on the front panel display of the Agent machine.
The supported machine model for an Agent: MAGNIA Z300/Z310
(3.3.15 Configuration screen)
Performance display function
It is the function to display the performance of the Agent machine. If threshold values are
set, events will be written to the event log on the Agent machine when each value
exceeds the specified threshold.
(3.3.1 Summary screen)
(3.3.13 Performance screen)
Mobile IP Software function
It is the function to display the information about the Mobile IP Software Server. (It is an
optional product.) Please refer to User's Guide of the Mobile IP Software.
The versions of the Mobile IP Software Server that the HEW supports are Ver.2.0, 2.1 and
2.2.
The supported machine model for an Agent: MAGNIA Z300/Z310/Z500
(3.3.6 Mobile IP Software screen)
Software Access Point function
It is the function to display the information about Software Access Point.
Please refer to User's Guide of the Software Access Point.
The version of the Software Access Point that the HEW supports is Ver.2.0.
The supported machine model for an Agent: MAGNIA Z300/Z310/Z500
(3.3.7 Software Access Point screen)