Toshiba Portege 3490 - Manual (Page 19)

Multi Media Port Replicator User’s Manual 19
Version
1
Last Saved on 13/03/00 17:13
User's Manual – Port_Rep.doc – PART 01 -- ENGLISH – Printed on 13/03/00 as 01_PRep
GB
Installing the PC card
A PC card slot accommodates one 5 mm PC card (Type II). Windows
allows hot installation of PC cards, which means you can install a card
while the computer’s power is on.
To install the PC card, follow the steps below.
1. A dummy card is installed in the Multi Media Port Replicator when it is
shipped. To eject the dummy, pull out the PC card eject button and
push it in to pop the dummy card out slightly.
2. Pull the dummy card out and store it in a safe place. Install the dummy
card to protect the slot whenever you remove the PC card.
Removing the dummy card
3. Insert the PC card. When the card is almost fully seated, you will feel
some resistance. Press gently to ensure a firm connection, but do not
force the card into position.
4. Pull the eject button out fully, then fold it down.
Inserting the PC card
5. Check the configuration in the Hardware Setup or TSETUP program to
make sure it is appropriate for your card.