Pioneer DBR-TF100GB - Manual (Page 7)

Getting ready 01
7
0 Refer to Setting TV codes on the right.
This remote can directly control the TVs of
major manufacturers. At the time of ship-
ment the remote is preset to operate
Pioneer TVs.
- SUBTITLE button (P.27)
Press to display subtitles.
= WIDE button (P.29)
Press to switch between wide-screen
viewing modes.
~ EXIT button
Press to remove on-screen displays.
! MENU button
Press to display the menu screen.
@ RETURN button (P.14)
• Press to select the last displayed
channel.
• Press to return to the previous menu
screen.
Putting batteries in the
remote
To add or change the batteries, slide
open the battery compartment cover on
the back of the remote control by
pushing it down and sliding it open.
Add two new
AA batteries.
Setting TV codes
The remote can control the following seven
functions by entering a TV brand code from
the attached list.
• TV on/standby or off
• TV volume up/down
• TV channel up/down
• Sound mute on/off
• Switch between TV/AV input
1 Press and hold the TV STANDBY
button (A on the illustration), enter the 4-
digit TV brand code. (Refer to Chapter 9,
TV
brand code, page 33.)
2 Pressing the TV STANDBY button (A
on the illustration) again, should switch the
TV on/off.
3 If the TV fails to operate, repeat the
operation in Step 1 above, or enter a
different code for the same brand of TV.
• It might not be possible to use this
remote with some TV brands or models.
• If necessary, the remote can be reset to
the factory default setting. While
pressing the TV STANDBY button,
enter the code 9999.
DBR-TF100GB_03_08.p65 7/22/03, 12:14 PM 7