Pioneer DBR-TF100GB - Manual (Page 30)

Other options 08
30
2 Press 5/∞ to select Setup and press
SELECT. The Setup menu is displayed.
3 Press 5/∞ to select Installation and
press SELECT. The Installation menu is
displayed. Then, refer to the instructions
below.
• Press MENU or EXIT to exit the menu.
• Press RETURN to return to the previous
menu.
Add New Channels
You can add new channels to the channel
list.
Press 5/∞ to select Add New Channels
and press SELECT. Scanning starts. If new
channels are found they are added to the
channel list. The number of new channels, if
any, are displayed.
• To cancel scanning once it has started,
press EXIT. Scanning stops and a
message is displayed stating that
scanning has stopped.
Replace Existing Channels
Use Replace Existing Channels to update
information on channels and delete channels
that are no longer available.
Press 5/∞ to select Replace Existing
Channels and press SELECT. Scanning
starts. If new information about a channel is
found, the channel information is updated. If
some channels are no longer available the
channels are deleted.
• To cancel scanning once it has started,
press EXIT. Scanning stops and a
message is displayed stating that
scanning has stopped.
• If no channels were found, a message is
displayed asking you to check the aerial
connection.
Signal Check
1 Press 5/∞ to select Signal Check and
press SELECT.
2 Use the
2/3 buttons to select a
channel. The signal strength is displayed
numerically and with words and is updated
once every second.
3 Press MENU to leave.
DBR-TF100GB_27_32.p65 7/22/03, 12:15 PM 30