Pioneer DBR-TF100GB - Manual (Page 13)

Basic operation 04
13
Chapter 4:
Basic operation
Turning on/off
To turn on, press STANDBY or any
number buttons. When you press
STANDBY , the channel last viewed is
tuned in. When you press a number button,
the channel of the number button is tuned in.
Then the Info banner is displayed and
disappears after a few seconds.
• You can remove the Info banner
immediately by pressing EXIT.
To turn off, press STANDBY . The DTR
goes into standby mode.
Changing channels
Using the P +, – buttons
Press P +/– to change a channel up/down
from the list of available channels.
Hold down P +/– to rapidly move through the
channel numbers until the desired channel
number is reached then release the button.
The channel is displayed.
Using the number buttons
Enter a 3-digit number for the desired
channel. For example, if you want to tune in
channel 125, enter 1-2-5.
Or
Enter just the digits of the number of the
channel desired. For example, if you want to
tune in channel 5, enter 5.
• If a channel is not available for the
channel number input, ‘No service is
available on this channel’ is displayed for
a few seconds and the channel does not
change.
Using the channel list
1 If you press SELECT while watching a
programme, a channel list of six channels,
including the present channel, is displayed.
2 Press 5/∞ to see lower or higher
channels on the list.
• Press
2/3 to move to the previous/
next list of channels.
3 Press SELECT again to select a channel
to tune in.
DBR-TF100GB_09_15.p65 7/22/03, 12:14 PM 13