Pioneer VSX-920-K - Manual (Page 115)

Additional information 12
115
En
English
Français
Deutsch
Nederlands
Italiano
Español
Remote control
During playback of DVD-
Audio, the display shows
PCM. • This will occur when playing DVD-Audio material over the HDMI connection.
This is not a malfunction.
The power turns off
automatically and some
indicator flashes, or some
indicator flashes and the
power does not turn on. • See the Power section (page 108).
Symptom Remedy
Cannot be remote controlled. • Set the remote control unit’s remote control mode so that it matches the
setting on the receiver (see Operating multiple receivers on page 77).
• Check whether the receiver’s remote control mode is properly set (see
Remote Control Mode Setup on page 107).
• Try replacing the batteries in the remote control (see Loading the batteries on
page 8).
• Be sure to operate within 7 m and a 30º angle of the remote sensor on the
front panel (see Operating range of remote control unit on page 14).
• Check that there are no obstacles between the receiver and the remote
control.
• Make sure that there is no fluorescent or other strong light shining on to the
remote sensor.
• Check the connections of the
CONTROL IN jacks (see Operating other Pioneer
components with this unit’s sensor on page 37).
Other components can’t be
operated with the system
remote. • If the battery ran down, the preset codes may have been cleared. Re-enter the
preset codes.
• The preset code may be incorrect. Redo the procedure for entering preset
codes.
Symptom Remedy
VSX-1020_SYXCN.book 115 ページ ２０１０年３月１２日 金曜日 午前９時１０分