Pioneer VSX-920-K - Manual (Page 101)

The System Setup and Other Setup menus 11
101
En
English
Français
Deutsch
Nederlands
Italiano
Español
1 Select ‘Manual SP Setup’, then press
ENTER.
See Making receiver settings from the System
Setup menu above if you’re not already at this
screen.
2 Select the setting you want to adjust.
If you are doing this for the first time, you may
want to adjust these settings in order:
• Speaker System – Specifies how you are
using the B speaker terminals (see below).
• Speaker Setting – Specifies the size and
number of speakers you’ve connected
(page 102).
• Channel Level – Adjusts the overall
balance of your speaker system (page 103).
• Speaker Distance – Specifies the distance
of your speakers from the listening position
(page 103).
• X-Curve – Adjusts the tonal balance of
your speaker system for movie soundtracks
(page 104).
3 Make the adjustments necessary for each
setting, pressing RETURN to confirm after
each screen.
Speaker system setting
• Default setting: Normal(SB/FH)
There are several ways you can use the speaker
terminals with this receiver. In addition to a
normal home theater setup where they are
used for the front height speakers or front wide
speakers, they can be used for bi-amping the
front speakers or as an independent speaker
system in another room.
1 Select ‘Speaker System’ from the
Manual SP Setup menu.
See Making receiver settings from the System
Setup menu on page 100 if you’re not already at
this screen.
2 Select the speaker system setting.
• Normal(SB/FH) – Select for normal home
theater use with front height speakers in
your main (speaker system A) setup.
• Normal(SB/FW) – Select for normal home
theater use with front wide speakers in
your main (speaker system A) setup.
• Speaker B – Select to use the B speaker
terminals to listen to stereo playback in
another room (see Switching the speaker
terminals on page 73).
• Front Bi-Amp – Select this setting if
you’re bi-amping your front speakers (see
Bi-amping your speakers on page 22).
• ZONE 2 – Select to use the surround back
terminals for an independent system in
another zone (see Using the MULTI-ZONE
controls on page 73).
3 If you selected Normal(SB/FH),
Normal(SB/FW), or Speaker B in Step 2,
select the placement of the surround
speakers.
In a 7.1-channel surround system with
surround speakers placed directly at the sides
of the listening position, the surround sound
of 5.1-channel sources is heard from the side.
This function mixes the sound of the surround
speakers with the surround back speakers so
that the surround sound is heard from
diagonally to the rear as it should be.
1
• ON SIDE – Select when the surround
speakers is positioned right beside you.
• IN REAR – Select when the surround
speaker is positioned obliquely behind you.
4 When ‘Setting Change?’ is displayed,
select Yes.
If
No is selected, the setting is not changed.
You will return to the Manual SP Setup menu.
Note
1 Depending on the positions of the speakers and the sound source, in some cases it may not be possible to achieve
good results. In this case, set the setting to ON SIDE or IN REAR.
VSX-1020_SYXCN.book 101 ページ ２０１０年３月１２日 金曜日 午前９時１０分