Olympus LS-20M - Manual (Page 66)

4
EN
Low Cut Filter A n
The recorder has a Low Cut Filter function to
minimize low-frequency sounds and record voices
more clearly. This function can reduce noise from
air conditioners, projectors and other similar
noises.
[Off]:
Disables this function.
[100Hz]:
This setting will reduce the noise generated
from air conditioners or projectors. It is effective
for indoor recording.
[300Hz]:
Use this setting when sufficient effects cannot
be obtained with the [100 Hz] setting.
Note
• When the [Input Jack] setting is set to [Line],
the Low Cut Filter function is disabled (☞ P.67).
Self Timer A n
The self-timer function allows a certain amount
of time to elapse after you fully press the REC (s)
button and then starts recording or shooting. Set
this function according to the purpose of recording
or shooting.
[Off]:
Disables this function.
[beep 5sec]:
A beep tone sounds for 5 seconds and the
PEAK/LED indicator light flashes from 3 seconds
before recording or shooting starts.
[beep 12sec]:
A beep tone sounds for 12 seconds and the
PEAK/LED indicator light flashes from 3 seconds
before recording or shooting starts.
[metalic5sec]:
A rhythm count tone sounds for 5 seconds and
the PEAK/LED indicator light flashes from 3
seconds before recording or shooting starts.
[metalic12sec]:
A rhythm count tone sounds for 12 seconds
and the PEAK/LED indicator light flashes from 3
seconds before recording or shooting starts.
Notes
• To cancel the self-timer after it starts press the
STOP (4) button.
• Self-timer shooting is automatically canceled
after one shot.
• When the [LED] setting is set to [Off], the LED
does not flash during self-timer operation. After
the time set for the self-timer elapses, recording
or shooting starts automatically (☞ P.73).
• When the [Beep] setting is set to [Off], beep
does not sound during self-timer operation.
After the time set for the self-timer elapses,
recording or shooting starts automatically (☞
P.73).
Notes
• The recording level will be automatically
adjusted when the recording level is set to
[Auto]. Set the recording level to [Manual] to
use the recording level adjustment feature.
• When the unit is set to [Auto], the limiter
function will be disabled. When a loud sound
is produced the level meter will swing all the
way over to the right while recording and the
PEAK/LED indicator light will turn on. When
this happens the sound will be recorded in a
distorted manner since the recording level is too
high. If sound distortions do not disappear even
after the recording level has been adjusted,
change the setting for microphone sensitivity
(☞ P.65) and adjust the recording level again.
• If too big sound is input, the noise may occur even
if [Rec Level] is set to [Auto] or [Limiter ON].
• The level can be adjusted from [01] to [12]. The
higher the number, the higher the level and the
larger the indicator position on the level meter.
Menu setting method
Menu setting method