Konica Minolta bizhub C451 - Manual (Page 214)

Setting up the PostScript driver (Windows) 6
C451 6-19
Specifying the center staple and fold setting
You can specify to center staple and fold a printed document. By specifying
the center staple and fold setting, printed documents can be folded in half
and stapled.
2
Reminder
The center staple and fold function is available only when optional finisher
FS-608 or finisher FS-519 with saddle stitcher is installed.
1
Click the Finish tab.
2
Select the “Center Staple and Fold” check box.
2
Note
The center staple and fold function cannot be specified when the staple,
punch, or fold function is specified.
The center staple function and the thick paper function cannot be spec-
ified when finisher FS-608 is installed.
Hole punching
Holes can be punched into the printed document.
2
Reminder
The hole punch function is available only when the punch kit is installed
on the optional finisher.
1
Click the Finish tab.
2
Select the “Punch” check box.
3
From the drop-down list, specify the number of punched holes.
2
Note
The hole-punch position changes according to the binding position spec-
ified from “Binding Position”.
The number of punch holes that can be selected may vary depending on
the punch kit that is installed.