Konica Minolta bizhub 42 - Manual (Page 29)

bizhub 42/36 4-3
4
7 Reset Press this key to reset settings (except programmed
settings) entered using the Control Panel and
Touch Panel. p. 4-4
8 Interrupt Press this key to enter Interrupt mode. While the ma-
chine is in Interrupt mode, the indicator on the Inter-
rupt key lights up in green. To cancel Interrupt
mode, press the Interrupt key again. p. 4-14
9 Stop Pressing this key while copying, scanning or printing
temporarily stops the operation. p. 4-4
10 Start Press to start the copy, scan or fax operation. p. 4-4
11 Keypad Allows you to specify the number of copies. Allows
you to enter the magnification. Allows you to enter
various settings. −
12 C (Clear) Clears a value (such as the number of copies, a
zoom ratio and size) entered using the Keypad. p. 4-4
13 Error Indicator Flashes in orange if an error occurred.
Lights up in orange when the service representative
is being called. −
14 Data Indicator Flashes in blue while a print job is being received.
Lights up in blue when a print job is queued to be
printed or while it is being printed. −
15 Utility/Counter Press to display the [Utility Settings] screen. From
the [Utility Settings] screen, settings can be speci-
fied for the parameters in the [Accessibility], [Meter
Count], [Address Registration], [User Settings], and
[Admin Settings] screens. p. 4-8
16 Mode Memory Allows you to register (store) the desired
copy/fax/scan settings as a program or to recall a
registered program. p. 4-11
17 Access If user authentication or account track settings have
been applied, press the Access key after entering
the user name and password (for user authentica-
tion) or the account name and password (for ac-
count track) in order to use this machine.
While logged on, press the Access key to log off,
and go back to the authentication screen. p. 4-12
No. Name Description Page