Konica Minolta FK-505 - Manual (Page 74)

4.1 Transmission Methods 4
Fax kit FK-505 4-13
F
a
x T
ran
sm
is
si
on
/R
ec
ep
ti
o
n
Me
th
od
s
Ch
apte
r 4
6 Using the 10-Key Pad, enter the
mailbox ID of the recipient.
❍ Enter the mailbox ID (SUB) (20
digits or less) registered for the
recipient.
❍ The only characters that can be used in the mailbox ID are 0 through 9, ,
and #.
❍ If the recipient is specified using a one-touch dial key or a speed dial number
also programmed with a SUB, the SUB is displayed as the mailbox ID. If
necessary, change the mailbox ID.
❍ To correct the mailbox ID, press the [No/C] key, and then enter the new
number.
✎
Note
The same ID cannot be used as the relay box ID and mailbox ID.
7 Press the [Yes] key.
8 Using the 10-Key Pad, enter the
password.
❍ Enter the password (20 digits
or less) if a password has been
set for the recipient’s mailbox.
❍ The only characters that can be used in the password are 0 through 9, ,
and #.
❍ To correct the password, press the [No/C] key, and then enter the new
number.
9 Press the [Start] key to begin scanning and sending the fax.
✎
Note
To stop a timer transmission, press the [Function] key to select “CANCEL
RESERV.”, and then perform the appropriate procedure (p. 4-20).
✎
Note
The recipient’s machine and mailbox settings must be specified.
In order for the recipient to check fax documents, the mailbox ID is needed.