Konica Minolta FK-505 - Manual (Page 51)

3 3.3 Basic Faxing
3-12 Fax kit FK-505
Fa
xin
g
Chap
ter
3
3.3 Basic Faxing
To fax using the Automatic document feeder
1 Press the [Fax] key.
The machine enters Fax mode,
and the fax screen appears.
2 Load the document to be faxed
into the Automatic document
feeder.
❍ Adjust the Document guide
plates to fit the size of the
document.
❍ Load the document face up.
✎
Tip
If a double-sided document is loaded into the Reverse Automatic document
feeder (option for bizhub 180), press the [Original] key until the “Duplex
Orig.” function is selected.
3 If necessary, change the “Resolution” setting (p. 3-11).
4 Using the 10-Key Pad, enter the
fax number of the recipient.
❍ The fax number of a previously
programmed recipient can also
be specified. Refer to “Dialing”
on page 3-2.
5 Press the [Start] key to begin scanning and sending the fax.
❍ To stop the fax transmission, press the [Stop] key, and then press the [Yes]
key in the next screen that appears.
❍ Once transmission is finished, a beep is sounded.
❍ If the fax could not be sent, the transmission result report is printed (p. 6-50).