Konica Minolta bizhub C284e - Manual (Page 149)

Authentication Manager 3
Authentication Manager 3-132
Editing a template
The information of a registered IC card information template can be viewed
and changed.
% Specify the settings for the template information to be changed, and
then click the [Apply] button.
–
The detailed settings vary depending on the type of the data
specified in a template.
– If "Bit" is selected for [Data Type], for settings, refer to "Registering
IC card information (when the data type is "Bit")" on page 3-132.
– If "Byte" is selected for [Data Type], for settings, refer to
"Registering IC card information (when the data type is "Byte")" on
page 3-133.
– To clear the entered information, click the [Clear] button.
Registering IC card information (when the data type is "Bit")
If the type of the data specified in a template is "Bit", configure the following
settings.
Template Name Type in the template name.
Data Type Select the data type of an IC card.
Scanning Start Position (Bit) Specify the card ID starting position.
ID Length (Bit) Specify the length of a card ID.
Conversion method of Card ID Select a method to convert a card ID.
• "Decimal": Converts a card ID to a decimal value.
• "Hexadecimal": Converts a card ID to a hexadecimal
value.
Minimum Number of Digits (Pad-
ding) Specify the minimum number of digits for card ID.