Advanced mode, Advanced mode -3 – Konica Minolta bizhub 42 User Manual
Page 97
bizhub 42/36
7-3
7.1
TWAIN-compatible application
7
Advanced Mode
Auto Deskew
Specify settings for correcting the skew of the image.
Paper source
Select whether to place originals on the Original Glass (Flatbed) or ADF.
When scanning documents from the ADF, select whether to scan only one
side or both sides of the document.
Original Size
Specify the original size.
Rotation
Select the orientation of the image to be scanned.
If the [Rotate back side] check box is selected, the back side of the image is
rotated 180 degrees and scanned. (Applies only when [Paper source] is set
to [ADF (2-sided)].)
Image size
Shows the data size of the scan image.
Close
Click to close the TWAIN driver window.
Prescan
Click to begin scanning a preview image.
Scan
Click to begin scanning.
Clear icon
Click to erase the preview image.
Preview window
Displays a preview image. Drag the rectangle over the image to select an ar-
ea.
Before/After (RGB)
Move the pointer in the preview window to display the color tones at the
pointer’s position before and after adjustments.
Width/Height
Displays the width and height for the selected area in the selected measure-
ment units.
Item
Description
Item
Description
Load
Specify a saved settings file (dat file) for scanning.
Save
Save the current settings as a settings file (dat file).
Default
Return all settings to their defaults.
Help icon
Click to display the help information.
About icon
Click to display the software version information.
Paper source
Select whether to place originals on the Original Glass (Flatbed) or ADF.
With scanning documents from the ADF, select whether to scan only one
side or both sides of the document.
Original Size
Specify the original size.
Scan Type
The type of scanning can be specified. Select the type from Full Color, Gray
or B&W.
Resolution
Select the resolution from 150dpi e 150dpi, 300dpi e 300dpi, 600dpi e
600dpi, 1200dpi e 1200dpi, 2400dpi e 2400dpi, 4800dpi e 4800dpi.
Scale
Specify the enlargement or reduction ratio for the selected area.
If [Resolution] is set at 1200 e 1200dpi or higher, a setting larger than 100%
cannot be specified.
Scanning Mode
Select [Auto] or [Manual]. When [Manual] is selected, a tab appears so that
detailed settings can be specified, for example, for [Brightness/Contrast],
[Filter], [Curves], [Levels], [Color Balance], and [Hue/Saturation].
The parameters that can be set differ depending on the scanning mode that
is selected.
The detailed settings that appear differ depending on the setting selected for
[Scan Type].
If [Auto] is selected as the scanning mode, scanning from the Original Glass
is performed after a prescan is performed so that a preview image can be
checked.
Image size
Shows the data size of the scan image.