beautypg.com

2 error messages, Error messages -3 – Konica Minolta bizhub 42 User Manual

Page 144

background image

bizhub 42/36

11-3

11.2

Error messages

11

11.2

Error messages

If the machine encounters a problem, an error dialog will appear and display one of the following error mes-
sages. Take corrective actions by referring to the table below.

If a communication error persists, please contact your service representative.

Message

Cause

Remedy

[Job Registration Limit Over]
[Registered jobs reached limit.

Wait for job registration to com-
plete.]

The number of requested jobs
exceeds the number of registra-
ble jobs.

Wait until the jobs complete or
delete the current job.

[Memory Full (Scan)]
[Insufficient memory.

The job is cancelled.]

The memory becomes full while
originals are being scanned.

Decrease the number of origi-
nals.

[HDD Over Capacity]
[Insufficient HDD capacity.

Delete unnecessary file.

The job is cancelled.]

There is not enough space avail-
able on the Hard Disk.

Delete the data stored in the
Hard Disk.

[Document Registration Limit
Over]
[Saved documents in folder
reached limit.

The job is cancelled.]

The number of registrable jobs
is exceeded.

Delete the data stored in the
Hard Disk.

[Scan TX Failed]
[Scan TX failed.

Job is cancelled.]

The scan transmission failed.

Wait for a while.
Cancel the job.

[Connection Failed]
[Check if the destination is cor-
rect.

The job is cancelled.]

The machine failed to connect.

Check whether the registration
of destinations is correct.

[Error Occurred during Writing]
[Check whether it is write-pro-
tected or out of space]

The machine failed to write data
to the USB memory device.

Cancel the job and check
whether the USB memory de-
vice is writable.

[The USB device is invalid.]
[Disconnect USB device.]

Incompatible device was con-
nected to the USB port.

Incompatible devices cannot be
connected.

[USB Connection Error]
[The same type of USB device
has been connected.

Please disconnect all devices.]

Multiple USB devices of the
same type are connected to the
machine.

Remove all USB devices con-
nected to the machine. When
connecting a USB device again,
be aware that multiple USB de-
vices of the same type cannot
be connected.

This manual is related to the following products: