Lenovo ThinkPad T540p - Manual (Page 77)

Performing a recovery operation
This section provides instructions on how to perform a recovery operation using the Rescue and Recovery
program.
1. From the Windows desktop, click Start ➙ All Programs ➙ Lenovo ThinkVantage Tools ➙ Enhanced
Backup and Restore. The Rescue and Recovery program opens.
2. In the Rescue and Recovery program main window, click the Launch advanced Rescue and Recovery
arrow.
3. Click the Restore your system from a backup icon.
4. Follow the instructions on the screen to complete the recovery operation.
Using the Rescue and Recovery workspace
The Rescue and Recovery workspace resides in a protected, hidden area of your hard disk drive that
operates independently from the Windows operating system. This enables you to perform recovery
operations even if you cannot start the Windows operating system. You can perform the following recovery
operations from the Rescue and Recovery workspace:
• Rescue files from your hard disk drive or from a backup
The Rescue and Recovery workspace enables you to locate files on your hard disk drive and transfer
them to a network drive or other recordable media, such as a USB device or a disc. This solution is
available even if you did not back up your files or if changes were made to the files since your last backup
operation. You also can rescue individual files from a Rescue and Recovery backup located on your local
hard disk drive, a USB device, or a network drive.
• Restore your hard disk drive from a Rescue and Recovery backup
If you have backed up your hard disk drive using the Rescue and Recovery program, you can restore the
hard disk drive from a Rescue and Recovery backup, even if you cannot start the Windows operating
system.
• Restore your hard disk drive to the factory default settings
The Rescue and Recovery workspace enables you to restore the complete contents of your hard disk drive
to the factory default settings. If you have multiple partitions on your hard disk drive, you have the option
to restore the factory default settings to the C: partition and leave the other partitions intact. Because the
Rescue and Recovery workspace operates independently from the Windows operating system, you can
restore the factory default settings even if you cannot start the Windows operating system.
Attention: If you restore the hard disk drive from a Rescue and Recovery backup or restore the hard disk
drive to the factory default settings, all files on the primary hard disk drive partition (usually drive C:) will be
deleted in the recovery process. If possible, make copies of important files. If you are unable to start the
Windows operating system, you can use the rescue files feature of the Rescue and Recovery workspace to
copy files from your hard disk drive to other media.
To start the Rescue and Recovery workspace, do the following:
1. Make sure that the computer is turned off.
2. Repeatedly press and release the F11 key when turning on the computer. When you hear beeps or
see a logo screen, release the F11 key.
3. If you have set a Rescue and Recovery password, type your password when prompted. The Rescue
and Recovery workspace opens after a short delay.
Note: If the Rescue and Recovery workspace fails to open, see “Solving recovery problems” on page 63.
4. Do one of the following:
• To rescue files from your hard disk drive or from a backup, click Rescue files and follow the
instructions on the screen.
Chapter 5 . Recovery overview 61