Kodak 5300 - Manual (Page 85)

Support
Bluetooth Device not Recognized
Probable Cause 1
The internal Bluetooth radio in the device may be turned off.
Corrective Action
Make sure the device is on and within range of the Bluetooth radio signal (30 ft., or 10 meters).
NOTE: The Bluetooth technology enabled device must use an BIP, OPP, or FTP profile.
Probable Cause 2
Sending device requires a PIN.
Corrective Action
Enter a PIN of 1111 into the sending device.
Device not Recognized
Any of the following can cause the prevent your Kodak EasyShare AiO from reading a connected digital
camera or memory card.
„ The camera is turned OFF.
„ The USB connector from the camera is not fully inserted in the port.
„ The memory card is not completely inserted.
„ The memory card is in backwards.
„ The memory card file system is corrupt.
Correct any connection problems and try again.
If the memory card file system is corrupt, reformat it in your camera.
Ink Cartridge
Color/Black Cartridge Not Recognized
The ink cartridge installed was not recognized. Generic or non-Kodak ink cartridges may not function in
the KODAK EASYSHARE All-in-One Printer. Kodak recommends using Kodak ink cartridges.
To correct the problem, install a genuine Kodak ink cartridge.
Ink Cartridge out of Ink
One of the ink cartridges has reached the end of its life and needs to be replaced.
To correct the problem, replace the expired ink cartridge.
Multiple Paper Feed
Multiple sheets of paper are pulled through printer.
User’s Guide 81