Kodak DP900 - Manual (Page 51)

Maintenance & Troubleshooting
3/99 49
Replacing the Batteries in the Remote
Control
The life of the batteries depends on how often and how long you
use the remote. Symptoms of low battery charge include erratic
responses when using the remote and a reduced range of
operation.
Follow these steps to replace the batteries:
1. Turn the remote face down in your hand.
2. Slide the battery cover off the end of the remote by pressing
on it with the heel of your hand.
3. Remove the old batteries.
4. Install two new AAA alkaline batteries. Make sure you install
each battery in the correct direction.
5. Slide the battery cover back on the remote.
Using the Kensington Lock
The projector has a Kensington Security Standard connector for
use with a Kensington MicroSaver Security System (Figure 26).
Refer to the information that came with the Kensington System
for instructions on how to use it to secure the projector.
Figure 26 Installing the Kensington lock