Kodak DP900 - Manual (Page 39)

Reference Manual KODAK DP900 / DP1100
36 3/99
Manual Sync
The projector adjusts signal synchronization automatically for
most computers. But if the projected computer image looks fuzzy
or streaked, try turning
Auto Image off then back on again. If the
image still looks bad, try adjusting the signal synchronization
manually:
1. Turn Auto Image off.
2. Highlight Manual sync, then press either mouse button
repeatedly until the image is sharp and free of streaks.
Manual Tracking
The projector adjusts tracking automatically to match the video
signal from your computer. However, if the display shows evenly
spaced, fuzzy, vertical lines or if the projected image is too wide
or too narrow for the screen, try turning
Auto Image off then back
on again. If the image is still bad, try adjusting the tracking
manually:
Note: The Manual Sync, Manual Tracking, Horiz. Position
and Vert. Position options are available only for computer
sources. The projector sets these options automatically for
a video source.
1. Turn Auto Image off.
2. Highlight Manual tracking, then press either mouse button
repeatedly until the fuzzy vertical bars are gone.
Positioning adjustments are saved when you power off the
projector.
Horizontal position
Follow these steps to manually adjust the horizontal position:
1. Turn Auto Image off.
2. Highlight Horizontal position, then press the left mouse
button to move the image right or press the right mouse
button to move the image left.
Positioning adjustments are saved when you power off the
projector.