Next Advance SP1800 - Manual (Page 46)

NEXT>>>ADVANCE www.nextadvance.com
SP1600/1800 Programmable Syringe Pump
Publication #1200-02 41 9/15/04
ALARM SETUP
AL [ ]
Set/query alarm setup mode. Set alarm enables or disables alarm buzzer mode.
POWER FAIL SETUP
PF [ ]
Set/query Power Failure mode. Set Power Failure enables or disables Power Failure mode.
TTL I/O OPERATIONAL TRIGGER SETUP
TRG [ ]
Set/Query TTL I/O Operational Trigger input configuration.
TTL I/O Operational Trigger is set to .
=> FT = Foot switch trigger (falling edge)
LE = TTL Level trigger (rising and falling edge)
ST = Start only trigger (falling edge)
SP = Stop only trigger (falling edge)
TTL I/O DIRECTIONAL CONTROL INPUT SETUP
DIN [ 0 | 1 ]
Set/query directional control input setup
Settings => 0 = Falling edge: Infuse, Rising edge Withdraw
Same as "dr:rE" setting from the keypad.
Use this setting with the CBL-TTL-1, reciprocating pump cable, to create a 2
pump continuous infusion system
1 = Falling edge: Withdraw, Rising edge Infuse
Same as "dr:dU" setting from the keypad.
Use this setting with the CBL-TTL-1, reciprocating pump cable, to create a 2
pump dual pumping system
PUMP MOTOR OPERATING TTL OUTPUT CONFIGURATION
ROM [ ]
Set/query Pump Motor Operating TTL output configuration (TTL pin 7)
Settings => 0 = Output is logic high only when the pump motor is operating (pumping).
1 = Output is logic high when the pump motor is operating (pumping) or when the
Pumping Program is executing a pause timer.
SET KEYPAD LOCKOUT
LOC [ ]
Set/query keypad lockout mode. Set keypad lockout disables changing any settings from the
keypad unless the "Lockout Disable Key" is inserted.
SET KEY BEEP
BP [ ]
Set/query key beep mode. Set key beep enables or disables key beep mode.
9.4.4 General Control and Status Commands
TTL I/O OUTPUT SETTING
OUT