Next Advance SP1070-M - Manual (Page 17)

NEXT>>>ADVANCE www.nextadvance.com
SP1000 series operator’s manual
Manual SP1000 series 10
6.10 ‘Program Phase #’ (Number) Key
When in the “Program Entry Mode”, momentary presses of the ’Program Phase #’ and the ‘Program
Function’ keys switch between the Program Phase number and the Program Function displays. The
Program Phase number will be displayed as
nn
, where ‘nn’ is the current Program Phase number.
When the Program Phase number is displayed and the current Phase’s function is a rate function, a
momentary press of the ‘Program Phase #’ key exits ‘Program Entry Mode, and displays the pumping rate.
To change the current Program Phase number, press the arrow keys below the Phase number’s digits. The
maximum Phase number is 41. To reset to Phase number 1, press and hold the ‘Program Phase #’ key until
the Phase number is 1.
When a new Program Phase number is selected, the current value of all settings will be that of the currently
selected Program Phase.
6.11 ‘Program Function’ Key
When in the “Program Entry Mode”, momentary presses of the ’Program Phase #’ and the ‘Program
Function’ keys switch between the Program Phase number and the Program Function displays.
With the Program Phase function displayed, the Program Function can be selected. Pressing any arrow
key, or an arrow key to the left of the colon (:) or decimal point (.) if displayed with the function, will select
the next Program Function. The selected function is stored by either pressing any non-arrow key, or after a
2 second delay. If the selected function is different then the original function, the display will blink when
the selected function is stored.
6.11.1 Program Phase Function Parameter
If the selected function has a parameter associated with the function, the value of the parameter will be
displayed to the right of the function name, separated by either a period (.) or a colon (:).
To change the parameter’s value, press the arrow keys below the parameter’s digits. The parameter’s new
value is stored by either pressing any non-arrow key or after a 2 second delay. If the parameter has
changed from its original value, the display will blink when the parameter’s new value is stored.
6.12 ‘Setup’ Key
The secondary function of the ‘Diameter’ key is ‘Setup’. While the Pumping Program is not operating,
press and hold the ‘Diameter’ key until the first setup configuration parameter, “Power Failure Mode”, is
displayed:
n
.
The display will consecutively display, for about 2 seconds, each Setup Configuration parameter and its
current setting. Pressing any non-arrow key will immediately advance to the next Setup Configuration
parameter.
To change a Setup Configuration parameter, press an arrow key under the parameter’s value. To store the
new value, press any non-arrow key or wait 2 seconds. If the parameter value differs from its previous
value, the display will blink. The new parameter value will be stored and the next parameter will be
displayed. See section 8, “Setup Configuration” for a complete description of the Setup Configurations.
After the last configuration parameter is displayed, the display reverts back to displaying the syringe
diameter. Any new parameter value will take affect immediately upon being stored.