WIKA IUT-11 User Manual

Page 44

Universal IS Pressure Transmitter UniTrans

Operation of Transmitters with Display

669

5 D

Subject to change due to technical modifications.

WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg · (09372) 132 - 710 · Fax - 706 · E-mail: [email protected] · www.wika.de

119

9.2

Key Functions

9.3

The Programming Mode

The transmitter can be programmed before or after installation.
The keypad is activated and the device can be programmed by simultaneously press-
ing the "esc" and "ok" keys (for 2 sec.). This method is used to access the main
menus. Each main menu has one or more sub-menus and each sub-menu, may have
its own sub-menus.

Button

Functions

Main Menu

Sub-menu

Edit Functions

back to the previous
menu option

increase value

forward to next menu
option

decrease value

back to value display
without saving

back to main menu
without saving

back without saving

to the sub-menu

to the edit functions

save value

activate keypad (push simultaneously; 2 s)

The keypad becomes inactive after 10 min. of disuse. All settings will de-
fault to previously stored values. Only settings that have been confirmed
with the "OK" function are stored.
A change in the starting measurement (zero point) has no effect on the
measurement span. Likewise, a change in the span has no effect on the
starting measurement.
An error signal occurs when the zero point or span settings fall outside of
the sensor’s nominal pressure range during calibration with pressure.
Nothing is saved.

This manual is related to the following products:

IUT-10