Astro Pneumatic 22834-464 - Manual (Page 53)

QLS-4100 X 53
To perform a Print Line Adjustment:
Press the NEXT or PREVIOUS key to cycle through the Print Line Adj menus until
the print station you want to adjust is displayed.
Press the + or - key to shift the selected print position in the desired direction.
Increasingly positive values will move the print position up on the label. Increas-
ingly negative values will move the print position down on the label.
Press the SELECT key. An asterisk (*) appears to confirm your choice.
Repeat steps 1 - 3 until each of the printed bars for stations 1, 2, and 3 are
properly aligned with the bars for station 4.
Note
An efficient way to shift the print line for a given print station is to
measure the variation from the reference bar in the test pattern. Recall
that print stations 1, 2, and 3 are adjusted while referencing print station
4. For example, if the bar printed on station 1 is measured to be
misaligned with the reference bar printed on station 4 by 2 millimeters,
you know that you need to shift station 1 by 24 pixels. The direction of
misalignment will dictate whether you move the print line +24 or -24.
Negative values adjust the line on the label away from the printer;
positive values adjust the line toward the printer.
1
2
3
4
Pause: Print Line Adj
Head 1 = -4 *