Kramer Electronics VS-812 - Manual (Page 22)

Operating Your Composite / s-Video / Audio Switcher
19
19
7.2 Switching and Distributing
Your VS-812 is both a switcher and a DA. The VS-812 simultaneously:
• Switches a converted signal to two video acceptors of the other format
• Distributes an input signal from the video and audio source to two video
acceptors of the same format
For example, Figure 16 illustrates how the composite video and audio source
# 3 simultaneously:
• Switches (and converts) to s-Video Acceptor 1 at the Y/C video OUT 1
connector and to s-Video Acceptor 2 at the Y/C video OUT 2 connector
• Distributes to CV Video Acceptor 1 at the composite video OUT 1
connector and to CV Video Acceptor 2 at the composite video OUT 2
connector
CV Video Source
CV Video Acceptor 1 CV Video Acceptor 2
Distribution Amplification
s-Video Acceptor 2
S-VHS
s-Video Acceptor 1
S-VHS
Switching (Converted Signal)
Figure 16: Switching and Distributing
To use your VS-812 as a 1:2+2 CV DA and an s-Video (Y/C) DA, as the
example in Figure 17 illustrates, do the following:
1. Connect the sources and acceptors, as follows:
 A composite video source to CV IN # 3
 A s-Video (Y/C) video source to Y/C video IN # 5
 A composite video acceptor to CV OUT # 1 and another composite
video acceptor to CV OUT # 2
 A s-Video (Y/C) acceptor to Y/C OUT # 1 and another s-Video (Y/C)
acceptor to Y/C OUT # 2
2. Set the INPUT SETUP switches, as follows:
 Pull the INPUT SETUP switch # 3 DOWN
 Pull the INPUT SETUP switch # 5 UP