1 connecting via rs232 using a pc, Connecting via rs-232 using a pc, Figure 5: connecting an unbalanced output – Kramer Electronics VS-812 User Manual
Page 11: Figure 4, Figure 5
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VS-812 8x1 Composite / s-Video / Audio Switcher
8
Figure 4: Connecting the Balanced Stereo Audio Input/Output
Figure 5: Connecting an Unbalanced Output
In addition (when using the Kramer Control software or other controller), you
can choose to connect several independent VS-812 units to a PC, as section
6.2 describes, and/or to connect a set of VS-812 units to a PC, as section 6.3
describes.
6.2 Connecting Several Independent VS-812 Units to a PC
This section describes preparing the RS-232 connectors (see section
),
adjusting Jumpers JMP4 and JMP5 (see section
), and setting the
DIP-switches on an independent VS-812 unit (see section
).
6.2.1
Connecting via RS-232 Using a PC
To connect a PC to an independent
• Connect the RS-232 9-pin D-sub rear panel port on the VS-812 unit to the
Null-modem adapter and connect the Null-modem adapter with a 9-wire
flat cable to the RS-232 9-pin D-sub port on your PC
VS-812 unit, using the Null-modem
adapter provided with the machine (recommended):
To connect a PC to an independent
Null-modem adapter:
• Connect the RS-232 9-pin D-sub port on your PC to the RS-232 9-pin
D-sub rear panel port on the VS-812 unit, as
on whether the PC has a 9-pin or 25-pin connector)
1 A stand-alone VS-812 unit, or up to seven independent VS-812 (or other Kramer) units that are controlled by a RS-232 port