Kramer Electronics VS-812 - Manual (Page 19)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your Composite / s-Video / Audio Switcher
16
7. Operating Your Composite / s-Video / Audio Switcher
You can operate your VS-812 via:
• The INPUT SELECTOR buttons (1 to 8) and the INPUT SETUP
switches (1 to 8) on the front panel
• RS-232 serial commands transmitted by a touch screen system, PC, or
other serial controller
7.1 Using the Front Panel Buttons and Switches
You can only select one
1
To select a video source:
video source at a time.
• Set the appropriate INPUT SETUP switch as required (UP for Y/C;
DOWN for CV), or preset up to eight INPUT SETUP switches, as section
7.1.1 describes
• Press one 2
7.1.1 Presetting up to eight INPUT SETUP Switches
INPUT SELECTOR button
The pressed INPUT SELECTOR button illuminates, indicating selection
and outputting of that video and audio source
You can preset
3
Figure 13
the INPUT SETUP switches of up to eight connected video
sources. For example, as illustrates, pull the INPUT SETUP
switches 1, 3, 4 and 7 UP, to preset these INPUT SETUP switches to Y/C.
Pull the INPUT SETUP switches 2, 5, 6 and 8 DOWN, to preset these INPUT
SETUP switches to CV.
Figure 13: Setting the INPUT SETUP Switches
Section 7.1.2 describes using the INPUT SELECTOR buttons on an
independent VS-812 unit and section 7.1.3 describes using the INPUT
SELECTOR buttons on a set of three looped VS-812 units.
1 One from the eight s-Video (Y/C) or eight composite video sources on an independent VS-812 unit, and one from the 49
s-Video (Y/C) or 49 composite video sources on a set of seven looped VS-812 units
2 You cannot press more than one INPUT SELECTOR button at a time
3 To save you time when using the same configuration