Kramer Electronics VP-771 - Manual (Page 64)

VP-771 - Port Tunneling 59
59
To setup and activate port tunneling on the VP-771:
1. Set the dedicated port tunneling Ethernet connection port type and port
number through which the VP-771 will be passing RS-232 signals.
By default, the dedicated port settings are TCP, 5050.
To change these settings see the “Port Tunneling Configuration” in the table
in Section
12.2
.
2. Set the DGKat UART command (the table in Section 12.2 ).
By default, the settings are 9600,8,N,1
3. Make sure that the VP-771 is connected to Ethernet.
The VP-771 is now ready to tunnel RS-232 signals via Ethernet port tunneling.