Fagor MV-200 - Manual (Page 14)

13
to be created may be used. To do this,
proceed as follows:
• Unroll and place the end of the roll in the
sealing area, then close the lid and press
down on both sides in the areas with the
raised dots until you hear the two clicks
indicating the lid has closed. (FIG 3)
• Press the “sealing button” (B). The
sealing light (E) will switch on.
• When the sealing light (E) switches off,
the bag has been sealed.
• Press the lid opening buttons (K) and
remove the bag.
• Cut the roll of bags to the desired size.
The bag is now ready.
Vacuum adjustment function
You may remove the bag when it reaches
the desired vacuum level. Follow the
standard procedure described above to
create the vacuum inside the bags. During
this operation, while the vacuum light (D) is
flashing, briefly press the "Stop" button (C).
After this operation, press the seal button
(B) to seal the bag.
5. MAINTENANCE AND CLEANING
Cleaning
• Wash your hands before cleaning the
machine and its accessories.
• Make sure the unit is unplugged before
cleaning it.
• Clean the outer surfaces of the
appliance with a damp cloth (no
detergent) before and after use.
• Do not use detergents or abrasive
products to clean the appliance
• Do not submerge the appliance in water
to clean it
Warning: Make sure the unit is unplugged
before cleaning it. If liquid is spilt
accidentally in any part of the unit, do not
plug it in or try to reuse it. Contact the
authorised technical service or supplier.
Re-using Fagor bags
If you want to re-use a used Fagor bag,
firstly you must clean it using neutral soap
and leave it to dry completely before using
6. TROUBLE SHOOTING
it again. They can also be washed in the
dishwasher.
Maintenance
The seals on the upper (G) and lower (J)
closures deteriorate with use and need to
be replaced with new seals.
Regular cleaning will prolong their lifetime.
The lower closure seal can be taken out for
cleaning. Press it to remove excess water
and dry it, then fit it back into the
appliance, pressing it in place. The upper
closure seal is glued to the appliance, so it
should be cleaned with a damp cloth and
pressed to remove excess water.
WARNING: Leave the lid open when the
unit is not in use, as closing the unit
deforms the seals and it will not create a
vacuum correctly.
You should reverse the position of the lower
seal from time to time. To do this, remove
the seal and replace it the other way round.
Here are the steps to follow if you
experience problems with the product.
The appliance does not work.
• Make sure that the unit is plugged in
correctly. Check the electrical socket by
plugging in another appliance.
• Check if the cable or plug is damaged.
If so, do not try to work it again.
• Check the bag is not covering the
vacuum nozzle (L). If it is, place the bag
under the vacuum nozzle (L) and press
the vacuum sealing button again (A).
The unit does not create a complete
vacuum inside the bags
• The open end of the bag should remain
completely inside the vacuum chamber
coupling.
• Check for impurities in the sealing seals
and the seals. Clean them and put them
back in the correct position.
• Turn the useful side of the lower seal
over by turning it.
• The bag could have a hole in it. To
check this, seal the bag with some air