AMX PTM-D15 - Manual (Page 33)

On Screen Display (OSD) Features
27 PTM-D15 15" Platinum Touch Panel
3. Exit the OSD by using the Save/Exit Icon ( ).
Adjusting Screen Brightness and Contrast
1. Press the Menu button ( ) to activate the OSD menu and change the Contrast.
2. Press the UP or DOWN button to highlight the Contrast icon ( ), then press INCREASE or
DECREASE to adjust the Contrast level.
3. Exit the OSD by using the Save/Exit Icon ( ).
Adjusting Display Performance (Clock and Phase)
Phase and Clock settings allow you to compensate for drift of computer signals. You can press the
Menu button ( ) to optimize both settings. If you want to fine-tune the settings for a specific
application, follow the steps below.
1. Press the Menu button ( ) to activate the OSD menu.
2. Press the UP or DOWN button to highlight the Clock icon ( ), then press INCREASE or
DECREASE to adjust the clock/picture performance.
3. Press the UP or DOWN button to highlight the Phase icon ( ), then press INCREASE or
DECREASE to adjust the phase (as seen on the following page).
4. Exit the OSD by using the Save/Exit Icon ( ).
FIG. 13 Adjusting Volume Level
FIG. 14 Adjusting Screen Brightness and Contrast
FIG. 15 Adjusting the Clock setting
Volume can also be adjusted by pressing the UP and
DOWN buttons when outside the OSD menu.
Increasing the value "stretches" the image to the right
Decreasing the value "contracts" the image toward the left/center