AMX PTM-D15 - Manual (Page 17)

Installation and Wiring
11 PTM-D15 15" Platinum Touch Panel
4. Connect a standard RS-232 cable to the Program Port on the front of the TPI/3 Touch Panel
Interface to the COM1 or COM2 ports on the back of your computer.
5. Verify that the PTM-D15 display is switched Off.
6. Provide power by either connecting the 4-pin AXlink cable from the Central Controller to the
AXlink connector port at the rear of the TPI/3 or by using a local PSN6.5 power supply. Use
the local PSN only if the distance from the power source exceeds the wiring lengths for the
TPI/3 as described in the AXB-TPI/3 Touch Panel Interface 3 Instruction Manual. The AXB-
TPI/3 beeps when you apply power and again when AXlink communication is detected.
7. Connect the Power Adapter to the female connector on the Power Cord and then connect the
Power Cord to an electrical outlet (FIG. 9).
Your system is now connected and receiving power.
FIG. 9 Connection of power cord to power cable