AMX PTM-D15 - Manual (Page 15)

Installation and Wiring
9 PTM-D15 15" Platinum Touch Panel
Connecting the cables on a PTM-D15 panel
1. Connect the VGA Input, Touch Screen Signal, and Power cables to the PTM-D15 touch panel
as shown in FIG. 7.
2. Once the installation of the Table Top Bracket and the connection of the appropriate cables are
finished, follow the steps in the Connecting to Optional Components section on page 10.
Using the VGA IN DB-15 (male) high-density connector
Connect the DB-15 (female) video connector to the VGA IN DB-15 (male) high-density connector
on the rear panel of the touch panel. The following table below lists the VGA IN DB-15 connector
pinouts.
FIG. 7 Attaching the cables to the rear of the PTM-D15
VGA Input cable -
to Monitor Out port Touch Screen cable -
Mouse Port on TPI/3 or
12 VDC connector - routes
power from the power cord and
adapter
Power Adapter
connects from panel
on TPI/3 connects from panel to
USB
Input
Audio
related touch interface
port
Do not plug in the power cord to the Power Adapter at this time. Power is supplied
after the entire system is wired together. Refer to the Connecting to Optional
Components section on page 10 for powering procedures.