AMX PTM-D15 - Manual (Page 13)

Installation and Wiring
7 PTM-D15 15" Platinum Touch Panel
Installation and Wiring
This section covers the steps necessary to setup the individual Platinum components and connect
them together. The three areas of focus are the main component setup, installation, wiring, and
connection.
Setting up the Panel
The setup of the Platinum Touch Panel involves unpacking the unit, attaching the particular type of
panel support, and connecting the appropriate cables.
1. Remove the panel from the shipping case.
2. Lay the back of the panel on a flat surface.
3. Fold up/out the base.
4. Remove the dust-proof plastic sheet (FIG. 4) from the screen (if applicable).
Table Top Installation (PTM-D15)
This process involves installing the support bracket and connecting the appropriate cables to their
respective locations/connectors.
Installing the Table Top support bracket
To avoid vibrations when you touch the display, install the Table Top support bracket. After
installation of the bracket, the display tilt angle is approximately 30-degrees from vertical.
1. While on a flat surface, use both hands to gently unfold (pull-down) the display stand by
flipping it downward (FIG. 4).
2. To fix the panel into position, hold the base with one hand and use the other to angle the panel
into position.
3. Insert the double-raised end of the Table Top Support Bracket (FIG. 5) into the fixing grooves
located on the display stand. One support bracket and two screws come with the PTM-D15.
There are two rows of fixing grooves on the stand.
FIG. 4 Removing the protective cover