Panasonic HDC-SD1 - Manual (Page 94)

94
VQT1A34
With a computer
Connection and recognition
After the software applications are installed, this
unit must be connected to the computer and be
correctly recognised by the computer.
≥Connect after installing the software
applications.
≥Remove the supplied CD-ROM if it is inserted
in the computer. (If the [Setup Menu] screen is
displayed, wait until it finishes and then remove
the CD-ROM.)
≥If the recognition procedure is not
accomplished properly, operation will not be
possible after connecting the unit to the
computer.
≥If the unit fails to operate normally, it may mean
that you have not conducted the installation or
recognition procedure properly.
1 Insert the battery and connect
the AC adaptor.
≥If you do not insert the battery and connect
the AC adaptor, operation will not be
possible after connecting this unit to the
computer.
2
Insert an SD card with recorded
images in this unit and then set
the mode dial to
to turn on
the power.
3 Connect this unit and a
computer.
A USB cable (supplied)
This unit is automatically recognised by the
computer.
≥Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
≥Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB cables.)
≥When the unit is connected to a computer,
the operation mode cannot be changed and
its power cannot be turned off.
In this case, disconnect the USB cable (l 96).
≥When a computer is accessing the SD card in
this unit, the card access lamp lights. (When a
card is being accessed,
appears on the
LCD monitor.) Do not disconnect the USB
cable or AC adaptor while the card is being
accessed as it may damage the data.
≥It may be necessary to reboot the computer
after connecting this unit to it for the first time.
Connection and recognition
procedures
PC
A
VQT1A34_GC_ENG.book 94 ページ ２００７年１月２７日 土曜日 午後１時４６分