Panasonic HDC-SD1 - Manual (Page 57)

57
VQT1A34
Recording
To return to automatic setting
Press the MENU button, then select [VIDEO] #
[MIC LEVEL] # [AUTO], and press the cursor
button.
≥Adjust the gain value so that the last 2 bars of
the microphone input level on the centre of the
screen will not light red. (Otherwise, the sound
is distorted.) Select a lower setting for gain
value or set [MIC LEVEL] to [AUTO].
≥The front left and front right gain values only
work when input is from an external
microphone.
≥The microphone input level meter shows the
largest volume for the microphones.
≥When [ZOOM MIC] is [ON], the volume will be
different depending on the zoom rate. Set
[ZOOM MIC] to [OFF] or set the microphone
input level after adjusting the zoom rate. (l 48)
Parts where white saturation (colour saturation)
is likely to occur (extremely brightly lit or shiny
parts) are displayed with diagonal lines (zebra
pattern).
¬ Rotate the mode dial to select .
Press the MENU button, then select
[ADVANCED]
# [ZEBRA] # [ON] and
press the cursor button.
A Zebra pattern
≥You can record an image with little white
saturation if you manually adjust the shutter
speed or brightness (iris/gain) (l 62).
To cancel the zebra display
Press the MENU button, then select
[ADVANCED]
# [ZEBRA] # [OFF] and press
the cursor button.
≥The zebra pattern does not appear on the
images actually recorded.
Zebra display
This is for displaying the parts that
are too bright.
A
VQT1A34_GC_ENG.book 57 ページ ２００７年１月２７日 土曜日 午後１時４６分