A&D Counting Scale HC-15Ki - Manual (Page 40)

38
Pcs On the ACAI
Weighing Pan Addition Range 60 63~122
10 13~26 70 73~138
20 23~49 80 83~152
30 33~70 90 93~166
40 43~89 100 103~299
50 53~106 over 200 203~492
As you add, the ACAI
annunciator will be
ON as long as you
are in range.
When you stop adding
and the display
becomes STABLE, the
ACAI annunciator will
blink.
After the new unit
weight is calculated,
the annunciator will
disappear,
3. Continue adding pieces within the ACAI range until you have reached a sample size
as large as the largest number of pieces that you will be counting.
‰ When you have added the maximum number of pieces required, remove the
sample pieces and start your counting job.
10-3. ACAI Manual Operation
‰ The ACAI procedure can also be controlled manually. The ACAI will not recalculate
the unit weight until the ENTER key is pressed (as long as it is at the proper time
and the guidelines in the ACAI Notes section have been followed).
‰ The ACAI manual mode is controlled by F-Function f-02-1, set at “2”.
‰ To start ACAI manual operation, the unit weight must be registered and the samples
still on the weighing pan.
1. Add pieces within the nearest ACAI range (refer
to table in the previous section). The ACAI
annunciator will stay ON as long as you are
within ACAI range.
2. Wait until the display becomes stable and
press the ENTER key.
When the new unit weight is calculated, the
indicator will blink for a moment and
disappear.
3. Continue adding pieces within the ACAI range until you have reached a sample size
as large as the largest number of pieces that you will be counting.
‰ When you have added the maximum number of pieces required, remove the
sample pieces and start your counting job.
STABLE
ACAI
STABLE |
ACAI
STABLE |
ACAI
888888 21
COUNT
WEIGHT UNIT WEIGHT
ACAI
888 2.331 8
8
111.000