A&D Counting Scale HC-15Ki - Manual (Page 25)

23
6. USING THE M+ MEMORY
6-1. The M+ Memory Function
‰ The scale can accumulate count data by pressing the M+ key, or automatically
(see the next page). It also keeps track of the number of times you add to the total.
‰ When you view the total by pressing the TOTAL key, you view the number of
pieces accumulated and the number of additions (how many times the total was
added to). Please see “6-2.” and “6-3.” to view or clear the total count.
Adding Using the M+ Key
‰ When stable count data is displayed:
1. Press the M+ key.
The scale will beep and the M+ annunciator
will blink for a few seconds.
If the scale beeps 4 times, or the M+
indicator did not blink, then refer to the
note below.
The M+ indicator will stay ON while
there is count in memory.
2. Press the M+ key every time you want to add to the count. Remember that you
may only add the count data once – the scale must return to near zero before it will let
you add again.
To Erase the Last M+ Addition
1. Press and hold the C key, then press
the M+ key – release.
2. The scale will beep and clear the last M+
addition.
If the scale beeps 4 times, there is no M+ addition to erase.
‰ The M+ key is accepted only once for every stable count data.
Once accepted, the M+ key is prohibited until the display
returns to less than +5d (1d = 1 weighing division).
‰ If f-03-02 is set at “1”, then the M+ key can accumulate
negative data. Once the M+ key is accepted, weight data must
return within ±5d before the next accumulation.
‰ To memorize the total count in the ID number, see “5-3. Unit
Weight, Tare & Comparator Limits Memorized”.
L
C
M+ +
M+
‘ ÑbeepÒ ‘
888.81 123
COUNT
TOTAL
M+