A&D Counting Scale HC-15Ki - Manual (Page 32)

30
9. F-FUNCTION PARAMETERS
9-1. To Change or View F-Function Settings
‰ Start with the scale switched off.
1. Press and hold the ZERO key, then press
the ON/OFF key.
The count display will show “f-00” with
“00” blinking. Then release the both keys.
2. Press the 0 Æ 9 keys to display the
number of the F-Function section.
‰ For example: the 5 key to enter into the
F-Function F-05-X Comparator section.
3. Press the ENTER key.
The count display will show the
F-Function and its present setting will
blink.
4. You may now either change the setting (Step
5) or move to the next F-Function (Step 6).
5. Use the 0 Æ 9 keys to change the
setting.
The C key clears the input setting if you press
the wrong key and want to re-enter.
If you make a mistake and want to escape without saving any changes made after
the last time the ENTER key was pressed – press the ON/OFF key to exit.
After the ENTER key is pressed, the data is entered.
6. Press the ENTER key to save any
changes and/or move to next.
7. When finished: press the ON/OFF key to
exit. Then, press it to turn the display back ON.
New settings will operate as set.
ON
OFF
ZERO +
8 f-00 810
8 f-05 810
8 f-05-01
88Clear8
8
aidal 0 0
00
8 f-05-01
88Clear8
8
aidal 1 0
00
ENTER
8 f-05-02
88Clear8
8
aidal 0 0
00
ENTER