A&D Counting Scale HC-15Ki - Manual (Page 28)

26
5. Press the ENTER key to save the setting
and move to next F-Function, f-05-02.
6. Continue to enter f-05 comparator settings
– refer to “9-2. F-Functions” for a listing. If
there are no changes to a F-Function, press
the ENTER key to move to the next.
7. When finished: press the ON/OFF key to exit. Then,
press it to turn the display back ON. Comparator
functions and limits will now operate as set.
Viewing Comparator Limits
‰ The comparator limits you are using will be shown by pressing the ½ key.
‰ Set f-09-01="0" to use this mode.
1. Press the ½ key, then upper limit
will be shown.
2. Press the ½ key again, then lower
limit will be shown.
3. Press the ½ key. The display will
return to normal.
Changing Comparator Limits Instead of Setting the F-Function
‰ Set f-09-01="0" to use this mode.
1. To change the upper limit, use the 0
Æ 9 10-key pad to display new
limit in step 1 above, and press the
ENTER key. Then new limit is
memorized and the lower limit will
be shown.
2. To change the lower limit, use the 0
Æ 9 10-key pad to display new
limit, and press the ENTER key.
Then the display will return to normal
with the new limit.
‰ Pressing the ½ key to go to next step,
the input data is not memorized.
These limits are held in memory even if power
to the scale is switched off.
8 f-05-02
88Clear8
8
aidal 0 0
00
ENTER
To ENTER
or
MOVE to next
ENTER
ENTER
888.8.- 102
COUNT
WEIGHT UNIT WEIGHT
88- 0.000 8
8
11 Hi 00
Upper limit
888.8.- 102
COUNT
WEIGHT UNIT WEIGHT
88- 0.000 8
8
11 Hi 00 ENTER
888.8.-1 98
COUNT
WEIGHT UNIT WEIGHT
88- 0.000 8
8
11 lo 00