Disconnecting the mower from the tractor, Disconnecting the mower from the tractor -33, Operation – Alamo 803213C User Manual
Page 99: Opera t ion
OPERATION
INTERSTATER 02/11
Operation Section 4-33
© 2011 Alamo Group Inc.
OPERA
T
ION
13. DISCONNECTING THE MOWER FROM THE TRACTOR
Before disconnecting the mower, the PTO must be
disengaged and all motion at a complete stop.
Move the mower to a level storage location and
lower both wings to the ground. If the mower will
be stored with the sections in the raised position,
be sure that the locks are engaged. If the mower
is not resting securely on the ground, block the
mower up securely before attempting to
disconnect it from the tractor. Use extreme care to
keep feet and hands from under the mower and
clear of any pinch points. OPS-F-0012
After disconnecting the 3 lift points, remove the
mower driveline from the tractor PTO shaft. Lay
the driveline down carefully to avoid damaging
the driveline or its shield. Do not let the driveline
fall into mud or dirt, which can contaminate the
bearing and shorten the life of the driveline.
OPS-F-0013
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
(SG-14)