Alamo 803213C - Manual (Page 59)

ASSEMBLY
INTERSTATER 02/11 Assembly Section 3-19
© 2011 Alamo Group Inc.
ASSEMBL
Y
CONTROL CABLE CONNECTION TO CONTROL STICK ASSEMBLIES
First remove the Cross-Screw from the bottom of
the Control Stick Assembly. DO NOT remove the
screws that fasten the two housings halves
together. ASMP-FL-0001
Next while holding the housing, fully shift the
Handle in the Control Stick Assembly to expose the
female-threaded end of the Plunger Rod. ASMP-
FL-0002
Then while holding the Handle to expose the
Plunger Rod, thread the Threaded Bead ASMP-FL-
0003 of the Cable into the end of the Plunger Rod
and tighten securely. Release the Handle, allowing
the Cable to pull into the Control Stick Assembly.
Once Cable is attached to Plunger Rod, slide the
silver Conduit Sleeve ASMP-FL-0004 into the
bottom of the Control Stick Assembly and align the
groove in the Conduit Sleeve with the Cross-Screw
Hole.
Finally Reinstall the Cross- Screw and tighten securely.