Alamo 803213C - Manual (Page 134)

MAINTENANCE
INTERSTATER 02/11 Maintenance Section 5-26
© 2011 Alamo Group Inc.
MAINTENANCE
Slip Clutch
A slip clutch is incorporated in the PTO driveline. It is designed to slip, absorb the shock load, and protect the
driveline.
After the first hour of operation, the slip clutch should be checked for overheating. After this first check, the
slip clutch should be checked weekly or anytime there is overheating. To adjust the slip clutch, tighten the
spring bolts 1/8 (maximum) turn at a time. Bolts should NEVER be adjusted to the point where the springs are
compressed solid. Minimum spring length is 1-1/8".
The slip clutch should be checked periodically and adjusted to compensate for wear. The lining plates are 1/8"
thick when new. Replace after 1/32" wear. If the mower has been idle for an extended period of time, or in wet
weather, before operating check to be sure the friction lining plates are not frozen or rusted together. Should
this freezing occur refer to the procedure described in the "Seasonal Clutch Maintenance" section on the next
page.
There are four friction lining plates in the slip clutch. These should be checked weekly for oil or grease, wear,
and moisture which could cause corrosion on the drive plates.
TANK FILLING INSTRUCTIONS
USE Tractor Hydraulic Oil only