Alamo 803213C - Manual (Page 49)

ASSEMBLY
INTERSTATER 02/11 Assembly Section 3-9
© 2011 Alamo Group Inc.
ASSEMBL
Y
Using the wire identified as “Ignition-Start” leading from ignition switch to starter solenoid, cut wire
approximately 3” from ignition switch. Using the internal and external bullet connectors provided, install the
“Line-connector” (internal) onto wire at ignition switch which is 3” long. Install the “Bullet-Terminal” (external)
onto the wire leading to starter solenoid.
ELECTRICAL CIRCUIT
Using ASM-FL-20-22 as a guide, install electrical
components and wiring.
Wires from the safety switch must be routed close
to cutter housing sidesheet and lift frame pivot
points. This will prevent wires from being stretched
and broken when cutter housing is raised or
lowered to maximum positions.
NOTE: Route wires in such a manner to prevent
interference with the operation of tractor or
INTERSTATER. Ensure that wires DO NOT lay
against anything which could wear through
insulation and cause a short circuit.
After connecting all wires, wrap wires with
flexguard tubing. Neatly gather hydraulic hoses
and flexguard tubing and strap together using
plastic ties.
NOTE: Be sure to install connector so that larger brown wires are located on bottom poles of switch. This
applies to Dual Wing and Single Wing applications.