Mounting and pump assembly, Lift cylinder frame attachment, Assembly – Alamo 803213C User Manual

Page 45: Assembl y

ASSEMBLY

INTERSTATER 02/11

Assembly Section 3-5

ASSEMBL

5. Lift the rear of the frame and secure with (4) 1/2" x 1 1/2" & (2) 5/8" x 1/3/4" bolts. Install the remaining front

hardware. ASM-FL-0006

MOUNTING AND PUMP ASSEMBLY

1. Before mounting tank, attach pipe manifold for

return lines to the return filter assembly.

2. Raise bumper with a forklift or hoist and lower

onto hydraulic tank supports. Attach the bumper
to the tank supports with (4) 1/2” x 2" bolts and
(4) 1/2" locknuts. ASM-FL-0007

3. Now tighten all hardware for mainframe, tank

support, tank, and bumper.

LIFT CYLINDER FRAME ATTACHMENT

Position the right and left lift cylinder supports and
loosely install the (6) 3/4" x 2-1/4" bolts and (6) 3/4"
locknuts to each side. Pull the supports outward and
downward to remove the slack, then tighten the
hardware. ASM-FL-0008
NOTE: On some applications Cylinder Support will
have an extra set of holes. Refer to Installation
Drawing for correct mounting.