Alamo 803213C - Manual (Page 46)

ASSEMBLY
INTERSTATER 02/11 Assembly Section 3-6
© 2011 Alamo Group Inc.
ASSEMBL
Y
Raise the left lift frame with the hydraulic jack and align frame with ears on main frame. ASM-FL-0009. Insert
the upper pivot pins with the lift frame ears on the outside of the mainframe ears. Secure the pins with the (2) 3/
8"x3/4" NF bolts and (2) 3/8" lockwashers. NOTE: Use Locktight
R
on bolts. ASM-FL-0010. Repeat procedure
for right side.
Mount the tilt and lift cylinders. The lift cylinder has
a 3" bore diameter and the tilt cylinder has a 3-1/2"
bore diameter. Be sure to remove the port caps
before extending the cylinders. Attach with (2)
cylinder pins and (2) 3/16" x 1-1/2" cotter pins to
each side. ASM-FL-0011.
NOTE: Mount cylinder so that hose connections do
not interfere when wings are raised and lowered.
For tractors equipped with a cab, a collar may need
to be installed on the lift cylinder rod for proper
alignment of the transport lock. Remove the
cylinder end and the locking collar. Install the extra
collar onto the rod and reassemble. ASM-FL-0011.
MOUNTING WING MOWERS
Assemble Skid Shoes on Cutter before mounting
the head. With the cutter housing tipped up, attach
housing shoes/wear plate. Carriage bolt attaches to
front mounting hole; plow bolts attach to middle and
rear holes. ASM-FL-0012
Position the cutter unit so that the outer pivots can
be assembled over the pivot pins. Attach the front
outer pivot to the lift frame using (4) 5/8 x 2-1/2 bolts
and (4) 5/8 locknuts.
Attach switch assembly and rear outer pivot to the
lift frame using (2) 5/8 x 3-1/2 bolts and (2) 5/8
locknuts. Install spacer (P/N 107242) between
switch assembly and lift arm. ASM-FL-0013
Attach magnet assembly to picot pin using bolts
and lockwashers provided. ASM-FL-0014.