Maintenance – Alamo 803213C User Manual

Page 132

Text mode
Original mode

MAINTENANCE

INTERSTATER 02/11

Maintenance Section 5-24

MAINTENANCE

Checking Relief Valve Pressure

1. To check the relief valve pressure setting, remove inlet hose at the control valve. Install a tee fitting and

reconnect the hose to a pressure gauge.

2. Check for proper tension on front drive belts (1/4 inch play at midpoint).
3. Start engine and run at low idle.
4. Raise the Tilt cylinder and note the pressure when the cylinder bottoms.
5. The pressure should be the same on both circuits, 1200 psi. If the pressure is 1200 psi on one and not on

the other, the relief valve and the pump are working fine. The problem would be somewhere else.

6. If pressure is low on both circuits, adjust relief valve. Remove hex cap, loosen lock nut (if present) and turn

adjusting screw clockwise.

7. If the pressure does not increase, remove the relief valve and inspect it. If the valve is good, the gear pump

is worn.