Sony PEG-TH55 - Manual (Page 109)

Customizing your CLIÉ™ handheld (Preferences) 109
Setting the Network preferences for a wireless LAN
E
AutoConnect :
When multiple profiles are registered on your CLIÉ handheld, an
appropriate profile for your location is automatically selected to connect
to a wireless LAN access point. If you select [Enable], the profile will be
one of the targets when the auto connect is performed. When you selected
[Enable], the profile name with “ * ” is displayed in the
Wireless LAN
Setup screen for profile list.
F
Advanced Setup
You can change the following settings by tapping [Advanced Setup].
Tap [OK] to return to the
Wireless LAN Setup screen.
When you disable DHCP and configure the following
settings manually
You do not need to disable DHCP for normal use. If you want to disable
DHCP, ask the administrator of the wireless LAN network.
• IP Address
• Subnet Mask
• Gateway Address
• Primary DNS
• Secondary DNS
When you disable [PowerSaveMode:]
Disable [PowerSaveMode:] for communicating with maximum power
when the wireless LAN is unstable. However, the battery power is quickly
consumed.
Select [PowerSaveMode:] for normal use.
When you need to select [Authentication:]
When any option other than [None] is selected for [WEP :] in C of step
5, you may need to select either [Open System] or [Shared KEY]
depending on your wireless LAN access point. In this case, select either
[Open System] or [Shared KEY].
Tip
You can register up to 30 profiles on your CLIÉ handheld.
Continued on next page
• • • • • • • • • • • • • • • • • • •