Adaptec SBC-599 - Manual (Page 82)

72 SBC-596/599 User's Manual
host adapter the highest priority on the SCSI bus. We
recommend that you leave the host adapter set to SCSI ID7.
n
SCSI Parity Checking - This option determines whether
the host adapter verifies the accuracy of data transfer on the
SCSI bus. The default setting is Enabled. You should
disable SCSI Parity Checking if any SCSI device connected
to the SBC-599 does not support SCSI parity; otherwise,
leave it enabled. Most SCSI devices do support SCSI parity.
If you are not sure whether a device supports SCSI parity,
consult the documentation for the device.
n
Host Adapter SCSI Termination - This option sets
termination on the host adapter. The default setting for the
on-board SCSI is low ON/High ON. If you want to manu-
ally set the termination setting, see SCSI Terminators for
appropriate settings.
Boot Device Settings
The boot device settings allow you to specify the device from
which you wish to boot your computer.
n
Boot Target ID - This option specifies the SCSI ID of the
device you wish to boot from. The default setting is SCSI
ID 0. The SCSI ID selected here must correspond to the ID
configured on the boot device.
n
Boot LUN number - If your boot device has multiple
LUNs (Logical Unit Numbers) and Multiple LUN Support
is enabled, this option allows you to specify which LUN to
boot from on your boot device. The default setting is LUN
0.
SCSI Device Settings
The SCSI device settings allow you to configure certain param-
eters for each device on the SCSI bus. To configure a specific
device, you must know the SCSI ID assigned to that device. If
you are not sure of the SCSI ID, see Using the SCSI Disk Utilities.