beautypg.com

Basic host adapter settings, Basic host adaptec settings default, Boot device settings default – Adaptec SBC-599 User Manual

Page 81: Scsi device settings default, Advanced host adapter settings default

background image

Chapter 6 SCSI Setup and Configurations 71

Basic Host Adaptec Settings Default

Host Adapter SCSI ID

7

SCSI Parity Checking

Enabled

Host Adapter SCSI Termination

Low ON/High ON

Boot Device Settings

Default

Boot Target ID

0

Boot LUN Number

1

0

SCSI Device Settings

Default

Initiate Sync Negotiation

Yes (Enabled)

Maximum Sync Transfer Rate

Yes (Enabled)

Enable Disconnection

20 MBytes/sec

Initiate Wide Negotiation

Yes (Enabled)

Send Start Unit Command

No (Disabled)

Advanced Host Adapter Settings Default

Plug and Play SCAM Support

Disabled

Host Adapter BIOS

Enabled

Support Removable Disks Under BIOS as Fixed Disks

2

Boot only

Extended BIOS Translation for DOS Drives >1 GByte

2

Enabled

Display Message During BIOS Initialization

2

Enabled

Multiple LUN Support

Disabled

Support for Ultra SCSI Speed

Disabled

1. Setting is valid only if multiple LUN Support is enabled.

2. Settings are valid only if host adapter BIOS is enabled.

Basic Host Adapter Settings

The basic host adapter settings are the SCSISelect settings most
likely to require any modification.

n

Host Adapter SCSI ID - This option sets the host adapter’s
SCSI ID. The default setting is SCSI ID 7, which give the

This manual is related to the following products: